Search results

Reef Aquarium & Tank Building Forum

Help Support Reef Aquarium & Tank Building Forum:

  1. M

    mkpaulson 210

    here is a shot of the tank looking up into it. and going to try to get a better pic later.
  2. M

    mkpaulson 210

    the ocean motion valve and pump were mounted in the cabinet this was the only place I could make it work far is room went.
  3. M

    mkpaulson 210

    a shot of the plumbing from behind the tank.
  4. M

    mkpaulson 210

    on the back of the tank I ran a 3/4 pine board along the top tank frame this was used to hold in place the rear outlet pipes I used 1-1/4 electrical conduit straps to anchor down the pipes to the pine board.
  5. M

    mkpaulson 210

    I ran the two front center pipes under the tank frame supports I drilled some holes in the support and ran the tie wraps through the holes and a around the pipe to hold it in place. the two front outer pipes were tie wrapped to the outer frame edge in the same manner.
  6. M

    mkpaulson 210

    the ocean motion mounted on the pump,PVC unions were used on the output of the valve and between the pump and valve.
  7. M

    mkpaulson 210

    my do-it-yourself strainer intake made out of 2 inch pvc.
  8. M

    mkpaulson 210

    Starting the next product on my tank is the ocean motion 8 way system with a sequence dart pump.
  9. top_l

    top_l

  10. up

    up

  11. vale_pump

    vale_pump

  12. top_c

    top_c

  13. top_tank

    top_tank

  14. pump_om8way

    pump_om8way

  15. pluming

    pluming

  16. pump_pvc

    pump_pvc

  17. DSCN1291_Medium_

    DSCN1291_Medium_

  18. back_tank

    back_tank

  19. intake

    intake

  20. 8-way2

    8-way2

Back
Top