Inert Sculpting Medium

[Inconservatory]

Hey all,

I am looking to sculpt some rockwork out of broken china and am looking for an inert, simple solution for binding them all together. I was using pond foam, but it is too unyielding and does not give a lot of time to fine-tune the design. Any suggestions?

 

[TJL]

Hey Jhustin, you could use Epoxy Stiks and would not need to be Marine/under water type if doing dry builds. Depending on brand/type from 5-20 minutes work-time and completely inert once cured. Sending you a pm

Cheers, Todd