DIY Nuclear Rocket C-Reactor prototype #1 Built by Ziggy also know as Chad
#1 An overall pic of the reactor and plumbing
#2 Shows the bell shaped bottom to recirculate the effluent (more on that later)
#3 Shot of "the fish room" But you cant see the recliner. AND its all in MY garage.
#4 A size reference and pic of the reactor with no plumming
#5 This is looking down the top of the reactor. *Note the 3/4" pipe inserted in the bottom of the reactor. This pipe has slits on the underside and is the "OUT" of the system and does not allow CO2 or effluent to escape after one time thru the media like top exiting reactors. There are 1 inch holes around the circumference of the internal body of the pipe.These holes are 8 or so inches above the 3/4" OUT pipe which forces water and CO2 in and up thru the media to recirculate continuously bypassing the out pipe. Only fully saturated water can exit without CO2 in its gaseous form.See #8 for diagram.
#6 Thru in a sump pic, The skimmer has the effluent and PH probe & collector connected to the air intake so all effluent goes thru the skimmer to be processed
#7 Work bench with Kalk, C-Reactor, timed peristalic pumps controlling additives which are on the top shelf
#8 A diagram of the inner and outer shell/s of the reactor. Things were blacked out for your protection
***This is still in testing and any input or questions are welcome****
One test I am currently performing...........
I took the reactor down to 6.50, 10 bubbles & 40 drops per min
and then turned off the CO2 and as of now 1:12am the Co2 has been off 16 hours and the PH is at 6.65. Alk at over 30dkh(API) and Ca at 31 drops (API) 700+?/////
Ps it was easier to build than it was to describe I apologize for the run-on sentences.
Chad