mercenary-grunt
Well-known member
I need help setting up my controller. The box didn't have clear instructions. Do I cut the power cord and attach that to the dosing??
Orp controller
- Thread starter mercenary-grunt
- Start date
Help Support Reef Aquarium & Tank Building Forum:
mercenary-grunt
Well-known member
It is a hanna intstruments hi 982411-0. I'll see about getting a pic soon.
mercenary-grunt
Well-known member
My ozone.
Sent from my MB525 using Tapatalk
Sent from my MB525 using Tapatalk
mercenary-grunt
Well-known member
I hope I got the right one, dang I feel like a super-noob right now. I was told this will do it.
Sent from my MB525 using Tapatalk
Sent from my MB525 using Tapatalk
mercenary-grunt
Well-known member
ok i finally remembered to get pics. here they are:
Ok well this is a unit I have not seen before?? I tried finding some kind of link and no luck their either?? Is their an air supply to this unit?? or a built in air supply?
The concept is that an air pump drives air through the ozone unit and past the corona inside, and then it goes to an air stone you put in your skimmer. The controller would then measure the orp in your tank and shut down the ozone unit if it gets to high. Does it look like your unit is capable of this??
Mike
The concept is that an air pump drives air through the ozone unit and past the corona inside, and then it goes to an air stone you put in your skimmer. The controller would then measure the orp in your tank and shut down the ozone unit if it gets to high. Does it look like your unit is capable of this??
Mike
krisfal
Well-known member
Well I notice 2 things, 1) I am not seeing a probe (to measure the ORP) 2) It says it is an ORP meter, not a controller, which would make me believe it only monitors the ORP and does not have the ability to shut down the ozone unit.
mercenary-grunt
Well-known member
Sorry I see now I was not as understood as I thought. I have an ozotech ozone generator. The big blue box. I have a pump and a air dryer. I was looking to make my generator automatic so I did not have to keep unplugging it. I bought the controller (pic 1&2) and a meter because I was told that I just needed to make sure the out side was staying level (a dubble check). And I bought 2 probes. One for each. I have 2 hookes on the outside of my skimmer pump the air hooks to.so the pump pulls the air and water into the pump. I just dont know how to hook the controller to the generator.
Sent from my MB525 using Tapatalk
Sent from my MB525 using Tapatalk
