WELDON 3 or 4

[Myteemouse]

Where locally can I get some WELDON 3 or 4 so I don't have to order from internet?
Looking south of kent prefferably?

 

[mfinn]

Keltech Plastics, just off 38th on Pine st.

 

[Myteemouse]

sweet tacoma??

 

[Myteemouse]

THANKS FINN!
Gonna go there tommoro!
Maybe get a few scrap pieces for a frag rack and a coast to coast overflow!!!

 

[mfinn]

That is a cool store.
They have a big rack full of scraps that the charge by the pound for.


Just past the mall and take a right on Pine. About 3 blocks down on the left.

 

[Myteemouse]

Right I already map quested it!
I also want to run an extra bead of weldon on the inside of the seams of this new tank!
CHEAP INSURANCE!

 

[mfinn]

Right I already map quested it!
I also want to run an extra bead of weldon on the inside of the seams of this new tank!
CHEAP INSURANCE!

Ahh, not sure if I'd do that.
Weld-On might weaken the seams. Plus it is like water, no way to make a bead.

 

[fishoutofwater]

yea finns right. dont do that. it wont leak.

 

[mfinn]

If you make it over there (Keltech), don't forget to buy atleast one applicator bottle.

 

[Myteemouse]

Well Got a few scrap pieces to play with and they didn't have any bottles to buy of weldon so I bought an applicator (NEEDLE) and they put about half a bottle full for me!!!

 

[mister crabs]

DO NOT apply weldon to a seam thats already been done. It will dissolve the existing bond and the only way to ever get it to rebond is to dissasemble and ssand the edge and then reglue it. its not like glue its a solvent where it actually chemically weakens the two pieces of acrylic and then the solvent evaporates leaving the finished product.

 

[Myteemouse]

Right I'm gonna just gonns roll with it!
it held water today just fine!
Got some holes to drill and a overflow to install!