mwebber28
Well-known member
I changed my 2 250w MH approx 3 weeks ago. I started them off at 4 hours a day then made my way up to 6 hours last week. I did however forget to put some screens down to reduce the light. I woke up yesterday and saw some white tips on my acro, birdsnest and a tort. Seen in the pictures.
I would assume this is just a bleaching from too much intensity from thr new bulbs... However, this did not appear untill 2 days after I changed out my phosban in my reactor. My water parameters were and still are fine with the exception of my phos which was around .5ppm and now is near zero.
So does this look like a light issue or a too rapid of a reduction in phos from the water?
I would figure my bulbs are broken in by now as they have been running for 100+hours prior to any problems. To make sure though I have cut the lights back to 5 hours and placed 4 layers of screen down. I plan to remove a layer every 2 days.
I shut off my reactor and plan to restart it when I get home(at work now) but will put it on a timmer and limit it to 8 hours for another week and increase it by 4 hours every couple days untill its at 24/7.
Any thoughts? advice?
I would assume this is just a bleaching from too much intensity from thr new bulbs... However, this did not appear untill 2 days after I changed out my phosban in my reactor. My water parameters were and still are fine with the exception of my phos which was around .5ppm and now is near zero.
So does this look like a light issue or a too rapid of a reduction in phos from the water?
I would figure my bulbs are broken in by now as they have been running for 100+hours prior to any problems. To make sure though I have cut the lights back to 5 hours and placed 4 layers of screen down. I plan to remove a layer every 2 days.
I shut off my reactor and plan to restart it when I get home(at work now) but will put it on a timmer and limit it to 8 hours for another week and increase it by 4 hours every couple days untill its at 24/7.
Any thoughts? advice?