mellowhead
Active member
I have wondered this forever, but it never really mattered too much as I never kept anything that difficult. Now that I am on to sps, I have to ask. I was going to do a water change over the weekend and my RO water (before any salt) was super clear. I added some buffer and still very clear. After I added some salt it was still clear. Then when I added enough salt to make 35ppm the water goes cloudy...? I am using Reef Crystals salt mix. I want to say it is an inbalance in my chemistry that is causing this, but I am not sure. Well I decided to hold off on the change until tonight just to see if this water is still ok to use? I have seen this before, sometimes not as bad though. Any ideas?
MH.
PS - Water was aerated and heated before the salt went in.
MH.
PS - Water was aerated and heated before the salt went in.