Actually It will have three doors on the bottom front, one on the left side & a skinny tall door on the top right, & a hood door. The tank will set on the left side & the right side will be an extended cabinet, covered in 3/4" Oak plywood. It is 35 1/2" tall, 32" wide & 6' 6" long, plus the total height of 77 1/2" which is just enough to get through the back sliding door. I should get the Hayward Motorized ball valve next week, my next purchase will be one of three pumps Sequence 4200 for the top CL on the MBV, another for the bottom I think, which might be on a daily timer & last the sump return, not sure what I want for that pump. I will order a 50 gallon Oceanic pre drilled sump & make my own baffles for it. I have a Mad Dog skimmer that never worked right so I need to replace the junky pump needle wheel or make an air stone out of it, not sure yet. Later I'll put two LIII's reflectors & probably two 10k 250 watt Ushios on either the HIQ or standard PFO ballast, I'll later supplement with some sort of fluorescent mainly for color but also Pre & post sunrise. Later I plan on taking a stab of making a kalk reactor & I already have a carbon/phosphate reactor to add in. I still need to prep the wall & run extra breakers in the room before I move the stand to the final location, also I won't trim out the stand until after I get it in the house, It is very heave already, I'll custom fit each piece then stain in the garage & install afterwords to reduce stinking up the house.
Thanks all for the comments, I'll post as I make progress & take pictures but I warn you now this isn't going to happen over night.
Oh yea the tank is almost a 125g!
