-
If you have bought, sold or gained information from our Classifieds, please donate to Reef Frontiers and give back.
You can become a Supporting Member or just click here to donate.
They're out!!!
- Thread starter Krish
- Start date
Help Support Reef Aquarium & Tank Building Forum:
Krish
RF STAFF
You know...Morgan had an issue with his nano stream as well. Not sure what's up with this line because people are having different issues. Here's what happened to him...
http://www.reeffrontiers.com/forums/showthread.php?t=21997
http://www.reeffrontiers.com/forums/showthread.php?t=21997
I just wandered over to RC to post on tunze USA's forum and saw a lot of people were having my same problem. They attribute it to either "low voltage" or it being "tight" from the factory in which case it will loosen up.
Ill plug in the ole kilowatt when I get home to check the voltage. I sincerely doubt its low though given this is the first problem Ive encountered.
Ill plug in the ole kilowatt when I get home to check the voltage. I sincerely doubt its low though given this is the first problem Ive encountered.
Krish
RF STAFF
Yeah...Let us know what you figure out
As expected the voltage was fine(119.7). This weekend when Im doing my maintenenace Im going to take it apart too see if the shaft itself is loose. That is also a problem people seem to be running in too. Its a shame that they pushed the release of these so quickly. A few more months of testing could have saved them a lot of face. The tunze board on RC is literally full of people with the same problem. They have awesome CS though so Im not worried about not getting a working unit, just annoyed.
lizardarm
Reptilian Disco Biscuit
sounds like the same problem that people are having with the modded maxi jet power heads. is there any sort of little stop block that the prop will run into if it starts out backward?
