Weird blisters on my Montipora and Stylo's, Pics.

Reef Aquarium & Tank Building Forum

Help Support Reef Aquarium & Tank Building Forum:

Whiskey

Whiskey

Member
Joined
Nov 6, 2005
Messages
13
Location
Phoenix
I have a problem specifically with my Monties and Stylo's, the tissue in some areas, on some peices is blowing up like a balloon!

Specs, 125G SPS tank W/ 2* Tunze 6100 for flow on wave maker.


Mag = 1300
Alk = 10 Dkh
CA = 430 Ppm
Temp = 80-81 on a controller
N03 = undetectable
P04 = undetectable
PH = 8.05-8.4 by a monitor

All tests Salifert.

Instant ocean salt. Perams maintained by DIY 2 part on an autodoser.

100_8964.jpg


100_8962.jpg


100_8961.jpg


What do you think is going on?

Thanks,
Whiskey
 
Hey Whiskey!! Just wanted to say welcome to RF. Great to have you here.

Brian

Sorry I can't help with the blisters.:(
 
It has been reported in a few of my customers tanks. I'm unsure of what the cause might be. It doesn't appear to be harmful to the coral and goes away in time.

Regards,
Kevin
 
mungus said:
Hey Whiskey!! Just wanted to say welcome to RF. Great to have you here.

Brian

Sorry I can't help with the blisters.:(
Click to expand...

What's up? Thanks for the welcome! I'm afraid I can't place the name though,... What do you go buy at the board you recognize me from? Or better yet, since I'm so bad with names,... what is your avitar? :D

Thanks,
Whiskey
 
kevinpo said:
It has been reported in a few of my customers tanks. I'm unsure of what the cause might be. It doesn't appear to be harmful to the coral and goes away in time.

Regards,
Kevin
Click to expand...

I have been keeping a very close eye on this (Odviousally) and paying special attention to my weekly tests.

One thing I never test, and I'm stupid for not testing, is my Salinity. Randy's 2 part adds salt,... I knew that, but yet the last time I tested my salinity (Per my log) was 2 or 3 months ago.

Most of my corals didn't seem to mind the salinity of 1.032.

I've corrected this now, but the situation has not changed, most of the bubbles have popped now, leaving a fleshless spot where they were, but there is still one I am watching.

Whiskey
 
JaxReef said:
whiskey, wait until casey finds out you a leading a double life!
Click to expand...

You I recognize! (Nice Avitar :D) What's up man?

Not much of a double life, I have been registered since Nov 2005 and not made a single post. I don't even remember signing up, or anyone telling me about this place,.. but oh well I'm here now.

Whiskey
 
Not much. I come here to read, lots of great info on this forum and some well known pros in the hobby post here
 
JaxReef said:
Not much. I come here to read, lots of great info on this forum and some well known pros in the hobby post here
Click to expand...

I am going to spend some time looking around. It seems like I spend my life in search of good info, a rather boring, but worthwhile quest I think.

I've posted the pics of my blisters all over the place, and it seems that most people say that it happens then goes away, hopefully the same will happen for me.

Whiskey
 
I mix my water changes up at 1.024 because of the buildup from dosing so much. My tank target is 1.025 but usually just before a water change it's 1.026- 1.027. My tanks with less/smaller corals don't have that problem (yet :D ).
High salinity may have been the cause. The corals should recover in a few weeks. Please be sure to update us if they quickly recover.

Regards,
Kevin
 
Indeed I will, Thanks for your help.

I think I finally have my doser working right, I found that if you want the check valves in your autodoser to work properly you need to filter your DIY supps through a coffie filter, otherwise the small amount of undesolved "Junk" will clog your check valves and prevent proper pumping.

Some random pics for the heck of it :)

100_8383.jpg


100_8380.jpg


100_8382.jpg


100_8375.jpg


Whiskey
 
Whiskey said:
What's up? Thanks for the welcome! I'm afraid I can't place the name though,... What do you go buy at the board you recognize me from? Or better yet, since I'm so bad with names,... what is your avitar? :D

Thanks,
Whiskey
Click to expand...

You had helped me a bunch over at TRT with some demensions on an MRC-2. I may have even encourged you to sign up here to check out the DIY thread I never started:( . It sounds about the right time frame. I go by mungus on TRT but post very little there. I think my avatar may have been a packer helmet.

Hope you enjoy your stay!!!
BTW your tank looks great!!!

Brian
 
Last edited:
mungus said:
You had helped me a bunch over at TRT with some demensions on an MRC-2. I may have even encourged you to sign up here to check out the DIY thread I never started:( . It sounds about the right time frame. I go by mungus on TRT but post very little there. I think my avatar may have been a packer helmet.

Hope you enjoy your stay!!!
BTW your tank looks great!!!

Brian
Click to expand...

Aah, now I remember. Since becoming Mod over there I deal with so many people all the time that it tends to mush together.

How's your tank doing? Everything working?

Thanks!
Whiskey
 
BTW, how do you like the new Avitar? This was donated by someone who finally got fed up with the other more "holsum" Bo Peep avitar I had for ever. I also have "Super Bo Peep" I use at TRT now that's perty slick.

Whiskey
 
Whiskey said:
How's your tank doing? Everything working?
Click to expand...

It is doing all right. I never finished the skimmer. It's just about done but 3 kids in 4 years has consumed most of my free time.:lol: I bought a skimmer for time being. I have a bunch of needed equipment on its way as a xmas present to my fish and coral. Once I get that and put in a dedicated day or two on the tank it should be in really good shape. Maybe then I won't be to embarrased to post some picts.:lol:

Love the avitar BTW

Thanks
Brian
 
Good, I'm glad it's working out. I hear you about the free time though. At least you have a working skimmer anyway, DIY or not.

Let me know when you throw the pics up,
Whiskey
 
You must log in or register to reply here.

Latest posts

Back
Top